The metal foot, moulded and shaped to prevent any sharp edge, is pre-drilled in the centre for insertion of the elliptic section 40 x 80 mm (thickness 20/10) vertical tubular part.
The top of the leg is completed with a load-distributing bracket, pre-drilled according to the size of the holes/bushes under the top. The beam fits rigidly to the leg on
which special laser-cut slots have been made.
A telescopic version of the beams is also available; this, combined with the intermediate leg (with slots on both sides of the tube), allows in-line combinations. Lateral extension consists of an upside-down T leg joined to a telescopic metal beam (the same for all three lengths) which connects to the main beam, allowing cables to run underneath the top.
The cables can be run up/down inside the leg, allowing vertical routing of systems. The top bracket has a 55 cm beam depth-wise; it can be used for all top types: desk (d. 60, 80 cm) and extension (d. 60 cm).
Made of 28 mm thick melamine chipboard with ABS edging. On the underside they mount sockets to join the top into the structural parts. Desks may be 80 or 60 cm deep with a length of 100/120/140/160/180/200 cm. Desks may be 80 or 60 cm deep with a length of 100-120-140-160-180-200 cm.
Melamine and steel modesty panel for desks, frontal panel and hook-on shelf. Lateral hanging object holder (open and closed) and bag hook also available.
The (semi-elliptical) top or ‘peninsular’ end top allows two desks (depth 60 or 80 cm) to be joined together laterally (they will be separated by a 5 cm gap). The (end or intermediate) T-leg combined with the bracket allows the creation of independent supports without beams. The same applies for the cylindrical leg with a circular cross-section diameter of 60 mm.
Single-top conference tables with square-base leg can be made in the following versions: round diameter 80/100/120, square 120×120 and rectangular 200/250 x 100. By hooking together two tops on three legs we can get larger rectangular tables as 300/400 x 120.